eazyose.blogg.se - Weboost otr antenna

Locate the same firewall hole from inside of the vehicle cabin.

Locate a place where cables are already running through the firewall (rear wall of engine bay) to the inside of the cabin.

Before connecting the power supply, disconnect the vehicle battery leads to avoid any electrical shocks during installation.Use steps below as a draft/template of the general install of the power supply. Wiring The Power Supply To Vehicle Battery Use the Velcro® adhesive strip/adhesive strip provided and attach to desired location. The location should be at least 18 inches but no more than 36 inches from where the cellular device will be used. Identify a place to mount the In-Vehicle Antenna, either on the side of the seat or on the dash and mount. If installing with the Spring, disassemble and reassemble the 3-Way Mount as shown below. If the vehicle does not have built-in mounting points, a three-way mount is included that will work on vehicles with mirror rails. These are some typical antenna mounting points.

NOTE: The included spring should only be used on shorter masts variations. NOTE: When adding the side exit adapter hold the antenna vertically and screw the adapter from the bottom up.